Getting information about your SAS-installation

Below is a couple of commands that can be used to get information about your SAS-installation.

proc setinit;
run;

The Setinit-command will give you information about the SAS-products that your SAS-installation is licensed for.

proc product_status;
run;

The Product_status-command will give you information about the SAS-products installed on your system.
Keep in mind that there could be a difference between what’s licensed on your system and what’s actually installed.
The commands above will only give you information about the products installed for base-SAS. If you want information about what other SAS-products is installed on you system, then you can get this SAS-program from SAS and run it on your system.

Leave a Reply

Your email address will not be published. Required fields are marked *